The pH sensor module Measure the pH value in liquids using this pH-201 pH Probe with BNC Connector. It can easily be used with any 5 V microcontroller like Arduino board.
A temperature sensor built into the board allows for temperature compensation during pH value calculation. Using a microcontroller like for example an Arduino, you can read the temperature from Pin T0. The module has also two potentiometers: One for setting the sensor offset (next to the BNC connector) and a second one for setting a threshold for the D0 pin. D0 is set to HIGH as soon as the pH threshold is passed. By default, the offset is set to 0 V when a pH value of 7 is measured which means that acidic solutions cause a negative voltage. Using the offset trimmer you can set the voltage range to be between 0 and 5 V - which again equals 0 to 14 pH.
pH Sensor Module
Pinout:
- T0: Temperature, analog output
- D0: 3,3V output when measured pH value is higher than the set threshold
- P0: pH value, analog output
- GND: Probe ground
- GND: Sensor board ground
- VCC: 5V operating voltage
pH Sensor Module Specs:
- Operating Voltage: 5V
- Current Draw: up to 10 mA
- Temperature Range: 0 - 60˚C
- pH Range: 0 - 14
- Response Time: < 1 min
- Accuracy: ± 0.2 PH